Measurement program Conmes-DAQ is designed for laboratory or process use, using NI measurement cards.
Conmes-DAQ allows intuitive measurement configuration, data display, analysis and storage.

• measured data are stored on hard drive and displayed in real-time
• measurement duration is limited by the hard drive free space only

Measurement settings configuration:
• sensor calibration, calibration data storage
• sensor type, sampling rate configuration (maximum values depend on the measurement card),
• single channel reset, manual offset setting
• measurement duration setting (number of samples, time)
• settings storage
• measurement display in y(t) or x-y charts
• manual or automatic measurement start based on chosen channel signal amplitude or slope angle

Display:
• chosen channels to y(t) or x-y charts
• measurement details, notes
• of long measurements in parts
• precise measurement data reading using cursor
• printing of chosen channels and time axis

Analysis (optional):
• arithmetic functions (+, -, *, /, log(x), ln(x), sin(x), cos(x), ...)
• integration, derivation (differentiation), reference course
• frequency analysis, frequency filter (high-pass, low-pass, band stop, band pass)

Measured data storing
• Wide variety of measurement data storing (inc. spreadsheet)

System requirements
• PC with Celeron 500 or higher, RAM 128 MB or higher
• operating system MS Windows XP, Vista
• 10 MB Hard Disk space
• monitor resolution 800x600 or higher